With a single-chassis design, the N°326S achieves separation of audio circuit, control circuit, and power supply sections similar to that of the dual-chassis N°32. The internal structure of the N°326S separates these sections, while a steel shield box protects the power supply and other circuits against electrostatic and magnetic interference. Filtered AC power is routed outside audio circuit sections, providing audio circuits with the quiet, shielded environment essential for superior sound.
Like most high-performance audio components, the N°326S relies on clean, noise-free AC power to deliver maximum performance. Unfortunately, most AC power does not meet these standards. Common household appliances such as refrigerators, TVs, and computers often contaminate AC power lines with line noise, spikes, and other irregularities that make it difficult for audio circuits to perform up to their full potential.
To compensate for this, the N°326S offers a series of highly effective noise suppression and isolation techniques that begin filtering AC power for noise as soon as it enters the chassis. Audio and control circuit sections use independent power supplies, each with its own low-noise toroidal transformer. The audio circuit power transformer includes a Faraday shield between the AC power line and low-voltage secondaries for improved isolation.
Following the Mark Levinson tradition, the N°326S exceeds all reasonable expectations for a stereo preamplifier. Its flexible design including seven configurable inputs, separate main and record output connectors and complete surround sound processor integration allow it to accommodate a wide range of demands. Additionally, a series of advanced techniques shield the audio circuits, resulting in an incomparable sound befitting sophisticated music reproduction systems.
||Unless otherwise specified, these specifications indicate nominal values measured over a 20Hz to 20kHz bandwidth through balanced (XLR) connections.
|Analog Audio Inputs
||3 balanced (female XLR) stereo inputs; 4 single-ended (Mark Levinson-RCA) stereo inputs
|Analog Audio Outputs
||1 balanced (male XLR) stereo main output; 1 single-ended (Mark Levinson-RCA) stereo main output; 2 single-ended (Mark Levinson-RCA) stereo record outputs
|Communication and Control
||2 8-pin RJ-45 connectors for Link communication; 1 6-pin modular RJ-11 connector for RS-232 communication; 1 3.5mm mini-jack for trigger output; 1 3.5mm mini-jack for ir input
||10 to 40kHz, ±0.2 dB
|Total Harmonic Distortion (THD)
||< -94dBV, 20Hz to 20KHz (input terminated)
||0, 6, 12, or 18dB (line-level stage)
||100, 120, 220, or 230V AC power at 50 or 60Hz (preset)